MyMonte.com - A 1995 to 2007 Chevy Monte Carlo Community: Creak Noise From Door Glass When Driving Over Bumpy Roads (lube Wndw Regulator) #99-08-64-021 - MyMonte.com - A 1995 to 2007 Chevy Monte Carlo Community

Jump to content

TSB NOTES

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

ALL CONTENT IN THIS SECTION IS COPYRIGHT GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.

Articles are listed in alpha order.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Creak Noise From Door Glass When Driving Over Bumpy Roads (lube Wndw Regulator) #99-08-64-021

#1 User is offline   Manitcor 

  • Admin with a Slow Car
  • View gallery
  • Group: Root Admin
  • Posts: 15,727
  • Joined: 31-July 02

Posted 16 January 2008 - 10:31 PM

Subject: Creak Noise from Door Glass When Driving Over Bumpy Roads (Lubricate Window Regulator)

Models: 2000 Chevrolet Monte Carlo


Condition:
Some customers may comment that a creak-type noise comes from the side door glass while driving over bumpy roads. This noise is usually heard when the door glass is partially open to almost full down.


Cause:
This condition may be due to a lack of lubrication on the back side of the window regulator.


Correction:
Use the following procedure to correct this condition:
Removal Procedure
Remove the upper trim panel screw.
Remove the upper door handle bezel screw and the bezel.
Remove the door handle screws.
Disengage all the push-in fasteners. Remove the door trim panel.
Remove the water deflector.
Remove the energy absorber.


Installation Procedure


Figure 1


Lubricate the back side of the window regulator with silicone paste or grease in the area shown in the illustration.
Install the energy absorber.
Install the water deflector.
Install the door trim panel.
Install the door handle screws.
Install the door handle bezel using the screws.
Install the upper trim panel screw.


GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.


© Copyright General Motors Corporation. All Rights Reserved
1995 LS - 3400, S&S Headers, UD Pulley, ODBII Swap, Modded PCM, other various goodies

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic