MyMonte.com - A 1995 to 2007 Chevy Monte Carlo Community: Chatter/squeal Type Noise When Side Dr Wndws Are Lowered (remove Lower Lip) #99-08-64-020 - MyMonte.com - A 1995 to 2007 Chevy Monte Carlo Community

Jump to content

TSB NOTES

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

ALL CONTENT IN THIS SECTION IS COPYRIGHT GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.

Articles are listed in alpha order.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Chatter/squeal Type Noise When Side Dr Wndws Are Lowered (remove Lower Lip) #99-08-64-020

#1 User is offline   Manitcor 

  • Admin with a Slow Car
  • View gallery
  • Group: Root Admin
  • Posts: 15,727
  • Joined: 31-July 02

Posted 16 January 2008 - 10:31 PM

Subject: Chatter/Squeal Type Noise When Side Door Windows Are Lowered (Remove Lower Lip From Inner Belt Seal Strip)


Models: 2000 Chevrolet Monte Carlo


Condition:
Some customers may comment about a chatter/squeal type noise as the windows are cycled downward. This condition may be worse in wet conditions.


Correction:
Use the following procedure to correct this condition:


Removal Procedure:
Remove the upper trim panel screw and the upper trim panel (mirror patch).
Remove the door handle bezel screw and the bezel.
Remove the door handle screws.
Remove the push-type fasteners from the inner panel. Remove the trim panel.
Remove the inner belt seal strip.
With the inner belt seal removed, use a utility knife in order to remove the lower lip from the seal.


Installation Procedure:
Install the inner belt seal strip.
Install the trim panel using the push-type fasteners.
Install the door handle screws.
Install the door handle bezel and the screw.
Install the upper trim panel (mirror patch) and the screw.


GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information


© Copyright General Motors Corporation. All Rights Reserved.
1995 LS - 3400, S&S Headers, UD Pulley, ODBII Swap, Modded PCM, other various goodies

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic